Carbon Steel Weld Connection Tee | Class 3000 Enquiry
산업 소싱용
명확한 RFQ 준비
RELIA가 부품을 이해하고 다음 단계를 논의할 수 있도록 아래 정보를 포함하세요.
- 도면, 샘플 또는 참고 표준
- 재질 등급 및 선호 공정
- 치수, 공차 및 표면 처리
- 용도, 목표 수량 및 목적지
생산 일정, 포장 및 운송 조건은 사양과 거래 조건 합의 후 프로젝트별로 확정됩니다.
-
warranty1 yearcustomized supportOEM, ODM, OBM
-
TechnicForgedConnectivityWelding
-
shapeEqualhead codeHexagon
-
Surface TreatmentPaintingMounting hole diameter0.25 in
-
Pipe Class3000SizeCustomized Size
-
Product nameElbow
A welded tee enquiry should define the branch arrangement and identify the selected fitting before comparing class or wall references. For a project requiring Class 3000, state the governing standard and requested material scope. Keep the class requirement separate from wall-schedule requirements so the proposed tee can be assessed against a complete design specification.
Identify the Tee and Its Three Interfaces
Request a drawing showing both run ends and the branch connection, with the model linked to the quotation. Give the nominal size and mating pipe outside diameter at each interface. Define the required branch relationship and the dimensions needed for installation. Confirm that the selected model represents the requested tee before relying on a single size selection. Specify the actual weld connection and end preparation instead of assuming a particular joint style from a general welding label.
Separate Class Designation from Wall Schedule
Identify the applicable class standard and the material-dependent basis for the required designation. Define the wall-schedule convention independently and request the actual thickness mapping for each selected connection. Where STD or SCH80 is requested, establish the corresponding dimensional scope rather than treating either label as a direct pressure rating. Name the exact steel grade, and obtain manufacturing records if forged construction is a project requirement.
Complete the Joint and Service Design Review
Provide the fluid composition, operating pressure and temperature, together with fabrication requirements for the welded assembly. Request material, dimensional and design documentation supporting the selected tee and its joints. State any coating requirement separately from pressure or corrosion-service qualification. Finalize the enquiry with the approved three-interface drawing, grade, production evidence, standard-defined class basis, wall mapping and documented operating limits so each design requirement can be checked against the same proposed configuration.
모든 제품 문의에 필요한 기술 정보
최종 제품 확정 전에 요구사항을 준비하세요.
제품 페이지는 출발점입니다. 재고 매칭 또는 맞춤 생산 확정 전에 도면, 샘플, 인터페이스, 소재, 수량, 검수 요구사항을 검토합니다.
프로젝트 상황에 맞춰 이 제품을 상담하세요.
도면, 샘플, 참조품, 목표 수량, 용도 정보를 공유하세요. 미확정 항목은 검토 상태로 둘 수 있습니다.
